English日本語EspañolPortuguêsعربي
NEWS
Process for solving the problem of casting porosity
2025-12-04
The die-casting pores are widely found in castings. How to solve the hole defects of castings has always been a headache for many manufacturers. Because of the pores, many castings with pressure requirements have to be scrapped, resulting in waste of...
Knowledge of nodular casting
2025-12-04
The main application areas of ductile castings are electronic and electrical engineering, light industry, bearing industry, automotive parts industry and other parts processing, because these behaviors have high requirements for ductile castings. And...
Introduction to large castings
2025-12-04
For large castings, the most basic point of view is to solve the “thermal balance” of casting shrinkage defects. In the solidification process of large castings, the size of each part is usually reduced. The percentage of casting size shrinkage is ca...
Information about gray iron castings
2025-12-04
Gray iron castings adopt the lost mold, resin sand casting process, equipped with large gas tempering kiln, artificial aging, tempering and releasing internal stress, etc., to improve the precision of castings after processing. For high-precision mac...
Cast iron is more difficult to electroplate than cast steel？
2025-12-04
Cast pig iron parts, the surface is often uneven and porous, on such a surface will only get a rough and porous coating. In addition, on the surface of the pig iron, there is free graphite, it not only affects the combination of the coating and the m...
Casting in mechanical equipment application
2025-12-04
Casting is the most widely used. It is a method of pouring liquid metal into a casting cavity, and then getting a blank or part of a certain shape after it cools and solidifies. The proportion of liquid forming parts in machinery and equipment is ver...
Anhui Ningguo Keboer Foundry Base, to be put into production in 2022
2022-01-15
What ls Integrated Facilities Management (lFM)? Thailand is close to the equator and belongs to the tropical monsoon climate. It has a natural resource base, long sunshine hours and sufficient sunlight. It is a country rich in solar energy resources ...
A clear plan for the third phase of the Kobor factory
2023-06-20
What ls Integrated Facilities Management (lFM)? Thailand is close to the equator and belongs to the tropical monsoon climate. It has a natural resource base, long sunshine hours and sufficient sunlight. It is a country rich in solar energy resources....